Videx VX2200 Guide de dépannage télécharger pdf (Page 9)

PAGE 9 of 68 VX2200 TECHNICAL MANUAL VER1.5

DIGITAL PANEL MODE

The digital panel can be set to either MAIN MODE or LOCAL MODE. MAIN mode should only be used for

panels that call all users and on systems that include 2206N devices (One per block or one for every 180

apartments), use LOCAL mode for all other applications. To set a digital panel as MAIN MODE, power up

with the 0 button pressed. To set as LOCAL MODE, power up with ENTER pressed (The mode can also be

changed via the PC programming software.

To use the digital front panel with 3000 series intercoms and videointercoms, press the “ENTER” button

while powering up and wait until the display shows the message “S3000”, release the button.

To use the digital front panel with 900 series intercoms and videointercoms, press the “CLEAR” button while

powering up and wait until the display shows the message “S900”, release the button.

Additional programming notes

a. During the programming of the master door panel, all slave door panels will be off line. (This

inconvenience does not occur if the slave entrances are connected through Art.2206 on a separate bus);

b. If the programming of the MASTER device is wrong (Eg. Programmed as a SLAVE when it should be a

MASTER), an error condition takes place signalled by the message “ERROR!” on the display. To recover

from this situation keep the “0” button pressed until the display shows CODE. Perform the programming

again correcting the error. Alternatively programming a SLAVE as a MASTER can cause feedback

(Larsen effect) during the conversation (Only one master per level per block allowed).

c. The entering of values not admitted is signalled by an error message, the unit waits for a valid entry

before continuing on with the programming.

d. Pressing the “CLEAR” button, at any stage will clear the current data previously entered.

e. To enter a number to call the concierge (if present) while the concierge is in night mode, combine the

“flat number” (Concierge number) with the “ID PHONE” address n.1.

f. When using the door panel in MAIN MODE, the programming of each user will require the address of the

2206N (Block address) for which that user is connected.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 67 68

Pas de commentaire

Videx VX2200 Guide de dépannage Page 9